Picking Quick Tips And Tricks For Water Heater Installation

Plumbing Made Simple - Tips To Help You On Your Plumbing Projects

Are you intrigued by how your plumbing system works? Plumbing can be intimidating to many people on the surface, but it is really not that difficult to learn. Many plumbing issues can be addressed by a simple fix. You can start learning more about plumbing by reading this article for some useful tips.

Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.

When choosing a plumber make sure he is insured and licensed. This is very important. If there is a plumbing emergency, you want to make sure the plumber has met the training requirements of the state. If he is insured, this covers any accidental damage done while fixing your plumbing.

To avoid wasting water and having a potentially high water bill, check your home for leaky faucets periodically. Fix any leaks that you find right away. You may be able to do the repair yourself, but if not, you may have to seek the services of a plumber to make the repairs.

To prevent the pipes from freezing, it is advisable to seal off air vents, cracks and access doors. In order to keep the heat in and the cold out, you can try using insulation or caulk. In the event a leak occurs, make it a point to remind everyone where the master circuit breaker is so it can be shut off immediately.

Check carefully around the base of your toilet for any damage caused by leaks. Straddle your toilet by rocking it from foot to foot to see if there's any weakening or softness on the floor below you. You can wind up saving your get more info money simply by noticing the problem early on.

Find out the plumbing codes in your local area before starting any project. Plumbing codes can vary wildly from area to area and you don't want to run afoul of the codes. Visit your local building department to find out information or hire a plumber for a day to help you go over your plans and provide advice.

If your drain in any device is taking longer to drain water, then you may need to have your pipes professionally cleaned depending on the severity of the circumstances. Before you do this, there are several different products you can try. However, some of them are professional strength and all products should be used with caution.

Make sure that any exposed pipes in your home are insulated, especially those found in crawl spaces on the outside walls of your home. This will help keep them from freezing and causing you tons of problems. Frozen pipes can often be devastating and leave you with problems that are expensive to fix and no water in the middle of winter.

In the winter months, if you live somewhere where temperatures fall below freezing, leave your faucets on a little bit to let a thin stream of water through. This will help prevent the pipes from freezing, which could be a major problem for you and all the pipes in your home.

Never hire a plumber that is not licensed, insured and bonded. If the plumbing company cannot provide you with reference numbers for their credentials, move on quickly. It is a common question and it should be a no-brainer for them to provide them to you. If they have issues with you asking, take that as a big red flag.

If you are looking to get new piping in your home, try to stay away from copper ones. Copper tends to have problems, due to water and soil corrosion. It is also harder to install these kinds of pipes. Steel or lead pipes tend to offer the best quality and are the most durable.

Be sure that you check on your water meter when it is not being used. Then, check on the meter 8 hours later. If the meter has changed, even a small amount, this could be a sign that there is an undetected water leak, which can be a severe problem.

To summarize, you want to know that you are taking care of your plumbing job just the same as a professional would, but without the additional costs they would inflict upon you. Hopefully, this article was informative enough for you to tackle any plumbing issue that might come your way.

How to get a decent plumber without going round the U-bend

Finding the valves

You can also search for reputable tradesmen in England and Wales via the Association of Plumbing and Heating Contractors (APHC) and in Scotland and Northern Ireland through SNIPEF.

John Thompson, the chief executive of the APHC, says there really is no need to stick with the first available plumber that you stumble on.

"If you feel pressurised into accepting work without a full explanation, have the confidence to question or get a second opinion. Also check if the tradesmen has the right credentials to work on your appliances," he says.

Mind you, if water is pouring, or even just dripping from the ceiling, you will need to try and isolate the problems to minimise damage before the plumber arrives.

For major leaks, turn off the water supply at the main stop tap, usually in the kitchen. You might need to resort to turning off the water company tap at the boundary of the property. Older ones may also turn off your neighbour's supply.

Smaller internal leaks can be stopped using local isolation valves - usually next to the appliance or tap concerned. These may be less familiar to older consumers as they take the form of levers or are just turned with a screwdriver.

On a combi boiler the isolation valve will be located underneath the boiler.

Ian Ruddick

Image caption,

Turning the thermostat up too suddenly can push your boiler over the edge, says Ian Puddick

Lagging

Ian Puddick is the founder of the London Boiler Company. His team is well used to being called out to replace worn out boilers which give up the ghost when they are pushed too hard.

"What happens is that all of a sudden people turn the thermostat up, but this pushes your boiler over the edge," he says.

"Also where you have tanks in the loft, check the little one to see that it's full of water. These can work with little in them for years, but when you turn the temperature up it drives the system a bit harder and then it stops."

Mr Puddick also has a helpful tip for avoiding a big freeze in your loft.

"Once you have checked all your pipes and tanks are lagged, protected and covered, check underneath the water tank. If there's some insulation there just pull it out and leave that area clear so heat can rise and protect the tank."

Emergency repairs are costly. So to avoid being fleeced by an opportunist plumber, it's worth getting your pipes and systems checked and serviced by a reputable engineer before temperatures drop once again.